What WaterSafe registration means
WaterSafe is the umbrella body for the UK's Approved Contractor Person schemes (including APHC, CIPHE, WIAPS and SNIPEF). A WaterSafe-approved plumber has been assessed on their knowledge of the Water Fittings Regulations, which exist to stop poor installation work or substandard products contaminating the drinking water supply — not just general plumbing competence.
Aftercare after plumbing work
After a boiler installation or bathroom refit, you should receive a benchmark/commissioning checklist (for a boiler) or a written summary of the work done, which you'll want if you make an insurance claim or sell the property later. Keep it with your household paperwork alongside any appliance warranties.
Combi vs system vs conventional boilers
A combi boiler heats water on demand with no separate tank, suits smaller properties with one bathroom. A system boiler uses a hot water cylinder but no cold water tank, better for higher demand. A conventional (regular) boiler uses both a cylinder and a tank, common in older properties and useful where mains pressure is poor.
Immersion heaters and hot water cylinders
An immersion heater is an electric backup for heating water in a cylinder, useful if the boiler fails or as the main hot water source in an all-electric property. If yours is tripping the electrics or not heating water, it's sometimes the heating element itself rather than the boiler or cylinder at fault.
Protecting pipes in cold weather
Pipes in unheated spaces — lofts, garages, outbuildings — are the most common source of a winter burst pipe once temperatures drop below freezing for a sustained period. Lagging exposed pipework and keeping heating on a low constant setting during a cold snap, rather than off, are the two most effective preventive steps.
Boiler pressure and heating faults
Most combi boilers run best between 1 and 1.5 bar of pressure — too low and the heating cuts out, too high and the pressure relief valve can discharge. A plumber checking a heating fault will usually look at pressure, check for trapped air in radiators (bleeding), and check the pump and diverter valve before assuming a full boiler fault.
How many quotes should you get?
Three is a reasonable number for most plumbing jobs — enough to spot an outlier without asking too many people to visit for a straightforward repair. For a planned job like a bathroom refit, make sure each quote covers the same scope, since a lower price sometimes means less is included, not better value.
When plumbing work needs a Gas Safe engineer instead
Plumbers can install and repair most water systems, but any work on a gas appliance or gas pipework — a boiler, a gas fire, a gas hob — is illegal for anyone who isn't on the Gas Safe Register, by law. If a job involves both plumbing and a gas connection (moving a boiler, for example), check whether your plumber is also Gas Safe registered before booking.