Plumbing in a washing machine or dishwasher
Both need a cold water supply, a drain connection, and in most cases their own isolation valves so they can be disconnected without turning off water to the whole property. Using a shared valve with another appliance is a common shortcut that makes future repairs more disruptive than it needs to be.
What's involved in a bathroom refit
A full bathroom refit usually means removing the old suite, checking and often replacing the pipework behind it (since it's rarely accessible again once tiled over), first-fix plumbing before tiling, then second-fix (taps, shower, toilet cistern) once the room is finished. Waterproofing (tanking) around a shower area is a step worth confirming is included, not assumed.
Low water pressure — common causes
Low pressure can come from a partially closed stopcock, a fault with the water company's supply, scale build-up in old pipework, or (for a shower specifically) the type of shower valve fitted. A plumber can usually diagnose which of these it is by checking pressure at more than one fixture, rather than assuming it's the mains supply.
Boiler pressure and heating faults
Most combi boilers run best between 1 and 1.5 bar of pressure — too low and the heating cuts out, too high and the pressure relief valve can discharge. A plumber checking a heating fault will usually look at pressure, check for trapped air in radiators (bleeding), and check the pump and diverter valve before assuming a full boiler fault.
How long does plumbing work take?
A tap or valve replacement is usually under an hour. A full bathroom refit commonly takes 5 to 10 working days depending on scope, plus time for tiling and decorating that isn't part of the plumbing work itself. A boiler swap is typically a one-day job if it's a straightforward like-for-like replacement.
Red flags in a cheap plumbing quote
A quote significantly below the others is worth questioning before accepting — check it specifies the same quality of parts (a boiler make/model, not just "a boiler"), includes making good after any pipework is exposed, and covers testing before the job is signed off as complete.
Three steps to hiring the right plumber
First, check they're registered with a WaterSafe scheme (or Gas Safe too, if the job needs it) and ask for the registration number. Second, get a written quote that separates labour from parts. Third, ask what happens if the job uncovers a bigger problem — a good plumber will tell you before continuing, not after.
Do you know where your stopcock is?
Every property has a main stopcock (usually under the kitchen sink, though sometimes in a different location in older or converted properties) that shuts off the water supply. Knowing where it is and checking it turns freely, before you need it in an emergency, is one of the simplest things a homeowner can do.