What a good heating quote should include
A proper quote should specify the boiler make and model (not just "a combi boiler"), whether a powerflush is included, the warranty length, and what certificate you'll receive on completion. If a quote is missing the boiler model, ask before agreeing.
Gas fires and stoves — same Gas Safe rule applies
Installing or servicing a gas fire, gas stove, or gas oven/hob is gas work under the same legal framework as a boiler — it must be done by a Gas Safe registered engineer qualified in that specific appliance category, not just any gas-qualified engineer, since categories are appliance-specific.
Boiler warranties and workmanship guarantees
Manufacturer warranties on new boilers commonly run 5-10 years, but usually require annual servicing by a registered engineer to stay valid — check whether it has to be the same installer or any Gas Safe engineer. This is separate from any workmanship guarantee the engineer offers on their own installation work.
Understanding the labour vs materials split
The boiler itself is often the largest single cost, but labour, flue work, and any additional pipework or radiator changes add up. If a quote looks cheap, check it specifies the same boiler tier (entry-level vs mid-range) as a competing quote, not just a lower labour charge.
How long should a boiler last, and when to replace vs repair
Most boilers last 10-15 years with regular servicing. As a rough guide, if a repair would cost more than a third of a new boiler's price, or the boiler is over 10-12 years old and parts are getting harder to source, replacement is usually the better long-term value than another repair.
Heating emergencies — what to do
If you smell gas, don't use any electrical switches, don't light a flame, turn off the gas supply at the meter if it's safe to reach, and call the National Gas Emergency Service on 0800 111 999 before calling a heating engineer. For no heat or hot water without a gas smell, check the boiler pressure and any error code before assuming a full breakdown.
What is a powerflush and do you need one?
A powerflush clears sludge and debris from radiators and pipework using a pumped chemical flush — often recommended if radiators are cold at the bottom or the system is noisy, and standard practice before fitting a new boiler onto an older system so it isn't immediately clogged.
How heating engineer quotes work
Describe the current system (boiler type and age, number of radiators, any known faults) and heating engineers can give an initial estimate; the firm price usually follows a site visit, since pipework condition and access aren't always obvious from a description alone.