When plumbing work needs a Gas Safe engineer instead
Plumbers can install and repair most water systems, but any work on a gas appliance or gas pipework — a boiler, a gas fire, a gas hob — is illegal for anyone who isn't on the Gas Safe Register, by law. If a job involves both plumbing and a gas connection (moving a boiler, for example), check whether your plumber is also Gas Safe registered before booking.
Three steps to hiring the right plumber
First, check they're registered with a WaterSafe scheme (or Gas Safe too, if the job needs it) and ask for the registration number. Second, get a written quote that separates labour from parts. Third, ask what happens if the job uncovers a bigger problem — a good plumber will tell you before continuing, not after.
Common plumbing myths, busted
"A dripping tap is just cosmetic" — left long enough it wastes real water and can damage the fitting further. "Any handyman can fit a boiler" — boiler work involving gas connections legally needs a Gas Safe engineer, not just a plumber. "Bleeding a radiator fixes all heating faults" — it only helps with trapped air, not pressure or pump issues.
How plumbing quotes work
Describe the job, including whether it's an emergency, a planned repair, or a full installation, and mention access — under a suspended floor is very different from behind fitted units. Plumbers use this for an initial estimate; the final price is usually confirmed once they've seen the fault or the space in person.
What a good plumbing quote should include
A proper quote should state the scope of work, whether parts are included in the price or charged separately, an estimate of how long the job will take, and what happens if the job turns out to be bigger than expected once work starts (a common scenario with older pipework).
What is a power flush and do you need one?
A power flush clears sludge and debris from a central heating system's radiators and pipework using a pumped chemical flush — usually recommended if radiators are cold at the bottom, or before installing a new boiler onto an older system, so the new boiler isn't immediately clogged by old sludge.
Plumbing emergencies — what to do first
For a burst pipe or major leak, turn off the water at the stopcock (usually under the kitchen sink or where the supply enters the property) before calling anyone — this limits water damage while you wait. For no hot water or heating, check the boiler pressure gauge first; a common cause is low pressure, which some homeowners can safely top up themselves via the filling loop.
Heat pumps and eco-friendly heating options
Some plumbers also work on or alongside heat pump installations, though this is often a joint job with a heating engineer for the heat pump unit itself. If you're considering moving away from a gas boiler, it's worth asking whether your plumber does this work directly or partners with someone who does.