Common heating engineer jobs
Heating engineers install, service and repair boilers and central heating systems: annual boiler services, fault diagnosis, radiator installation and balancing, powerflushing, and full system replacements. Many also work on unvented hot water cylinders and, increasingly, heat pumps and other low-carbon heating.
Frozen condensate pipes in winter
A frozen condensate pipe (the small plastic pipe draining from a condensing boiler, often outside) is one of the most common winter boiler breakdowns — it causes the boiler to shut down as a safety measure. Pouring warm (not boiling) water over the pipe to thaw it, if safely accessible, sometimes fixes this without a call-out.
What size boiler do you actually need?
An oversized boiler costs more to buy and can run less efficiently; an undersized one struggles with demand, particularly hot water for multiple bathrooms. Sizing should be based on a heat loss calculation for the property and how many bathrooms/hot water outlets are used at once, not just the previous boiler's output copied across.
Common heating myths, busted
"Leaving heating on low all day is cheaper than on/off" — not reliably true; it depends on the property's insulation and the specific system. "A hissing boiler just needs bleeding" — hissing more often points to a pump or valve issue than trapped air. "Bigger boiler means faster hot water for everyone" — it's more about cylinder size and flow rate than boiler output alone.
Combi vs system vs conventional boilers
A combi heats water on demand with no tank or cylinder, suits smaller properties with one bathroom. A system boiler uses a hot water cylinder but no cold water tank, better where several taps might run at once. A conventional (regular) boiler uses both a tank and cylinder, common in older or larger properties, or where mains pressure is poor.
How heating engineer quotes work
Describe the current system (boiler type and age, number of radiators, any known faults) and heating engineers can give an initial estimate; the firm price usually follows a site visit, since pipework condition and access aren't always obvious from a description alone.
Water-based underfloor heating and your boiler
A water-based underfloor heating system runs off the boiler via a manifold, usually at a lower flow temperature than radiators, and needs the floor buildup to accommodate the pipework. It's often more efficient paired with a heat pump than a gas boiler, because of that lower operating temperature.
Oil-fired boilers, what's different
Oil boilers are common in properties off the mains gas network, need an oil storage tank with its own maintenance and safety considerations, and are serviced by OFTEC-registered engineers rather than Gas Safe (which only covers gas). If you're off-grid, confirm your engineer's OFTEC registration specifically.