Water meters and leak awareness
An unexplained rise in your water bill, or a water meter that keeps ticking over when nothing's running in the property, is one of the clearest early signs of a hidden leak. Most water companies can help identify whether the leak is on your side of the meter (your responsibility) or theirs.
What WaterSafe registration means
WaterSafe is the umbrella body for the UK's Approved Contractor Person schemes (including APHC, CIPHE, WIAPS and SNIPEF). A WaterSafe-approved plumber has been assessed on their knowledge of the Water Fittings Regulations, which exist to stop poor installation work or substandard products contaminating the drinking water supply — not just general plumbing competence.
Blocked drains — causes and what a plumber checks
Slow-draining sinks are usually a local blockage (grease, hair, food waste) that a plumber can often clear with rodding or a drain snake. A blockage affecting multiple fixtures at once, or gurgling sounds from other drains, points to something further down the system — sometimes needing a drain camera survey rather than guesswork.
Protecting pipes in cold weather
Pipes in unheated spaces — lofts, garages, outbuildings — are the most common source of a winter burst pipe once temperatures drop below freezing for a sustained period. Lagging exposed pipework and keeping heating on a low constant setting during a cold snap, rather than off, are the two most effective preventive steps.
Do you know where your stopcock is?
Every property has a main stopcock (usually under the kitchen sink, though sometimes in a different location in older or converted properties) that shuts off the water supply. Knowing where it is and checking it turns freely, before you need it in an emergency, is one of the simplest things a homeowner can do.
When plumbing work needs a Gas Safe engineer instead
Plumbers can install and repair most water systems, but any work on a gas appliance or gas pipework — a boiler, a gas fire, a gas hob — is illegal for anyone who isn't on the Gas Safe Register, by law. If a job involves both plumbing and a gas connection (moving a boiler, for example), check whether your plumber is also Gas Safe registered before booking.
First fix and second fix plumbing
On a new build or extension, "first fix" is running pipework through walls and floors before they're closed up; "second fix" is fitting the visible taps, radiators and appliances once decorating is done. Timing this with other trades on site matters — pipework needs to be pressure-tested before it's covered over, not after.
Immersion heaters and hot water cylinders
An immersion heater is an electric backup for heating water in a cylinder, useful if the boiler fails or as the main hot water source in an all-electric property. If yours is tripping the electrics or not heating water, it's sometimes the heating element itself rather than the boiler or cylinder at fault.