Boiler pressure and heating faults
Most combi boilers run best between 1 and 1.5 bar of pressure — too low and the heating cuts out, too high and the pressure relief valve can discharge. A plumber checking a heating fault will usually look at pressure, check for trapped air in radiators (bleeding), and check the pump and diverter valve before assuming a full boiler fault.
Combi vs system vs conventional boilers
A combi boiler heats water on demand with no separate tank, suits smaller properties with one bathroom. A system boiler uses a hot water cylinder but no cold water tank, better for higher demand. A conventional (regular) boiler uses both a cylinder and a tank, common in older properties and useful where mains pressure is poor.
Do you know where your stopcock is?
Every property has a main stopcock (usually under the kitchen sink, though sometimes in a different location in older or converted properties) that shuts off the water supply. Knowing where it is and checking it turns freely, before you need it in an emergency, is one of the simplest things a homeowner can do.
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.
Red flags in a cheap plumbing quote
A quote significantly below the others is worth questioning before accepting — check it specifies the same quality of parts (a boiler make/model, not just "a boiler"), includes making good after any pipework is exposed, and covers testing before the job is signed off as complete.
Seasonal plumbing checks worth doing
Before winter: check outside tap isolation valves, and consider draining down any external pipework not in regular use. Before summer: check garden irrigation and outside tap connections for wear, since these see much more use once the weather turns. A five-minute check avoids most seasonal callouts.
Common plumbing jobs
Plumbers handle everything from a dripping tap to a full bathroom re-pipe: fixing leaks, clearing blocked drains, replacing taps and valves, fitting new bathroom suites, repairing or replacing radiators, and connecting appliances like washing machines and dishwashers. Emergency work (burst pipes, no hot water) is usually handled separately from planned jobs like a bathroom refit.
What a good plumbing quote should include
A proper quote should state the scope of work, whether parts are included in the price or charged separately, an estimate of how long the job will take, and what happens if the job turns out to be bigger than expected once work starts (a common scenario with older pipework).