Bathroom plumbing work and WaterSafe
Moving or adding plumbing (a new shower, relocated toilet) should follow Water Fittings Regulations, the same rules a WaterSafe-registered plumber works to. If your bathroom fitter isn't a registered plumber themselves, ask who does the plumbing side and whether they're WaterSafe registered.
What affects the cost
Cost depends on whether pipework and electrics need moving (not just swapping fixtures in place), the tiling area, fixture quality, and whether structural changes are needed (like removing a bath for a walk-in shower). Moving a toilet's position, in particular, is one of the more expensive changes because of the soil pipe work involved.
Understanding the labour vs materials split
Tiles, the suite, and fittings are often a smaller share of the total cost than labour, particularly for a full refit involving tanking and tiling. A cheap quote is worth checking against the same fixture brands and tile spec as competing quotes, not just a lower labour rate.
Walk-in showers and wet rooms, what's different
A walk-in shower needs careful floor falls (gradient) toward the drain to work without a shower tray — this is more technically demanding than fitting a standard shower tray and enclosure, and a poorly built one is a common source of water pooling or leaks. A full wet room takes this further, tanking the whole floor.
Making the most of a small bathroom
A corner shower, wall-hung suite, and a mirrored cabinet instead of a separate cabinet and mirror are common ways fitters maximise a small bathroom without a full structural change. Layout planning matters more in a small space, where a few centimetres can determine whether a design actually works.
Three steps to hiring the right bathroom fitter
First, ask to see photos of similar completed jobs, ideally local ones. Second, clarify exactly who does the electrical and plumbing work — the fitter directly, or a subcontracted registered tradesperson. Third, get a written quote that separates labour, fixtures and tiling.
Planning bathroom storage during a refit
Built-in storage (vanity units, recessed cabinets) is far easier to plan during a full refit than to retrofit afterwards, since it often needs coordinating with tiling and plumbing runs. Worth deciding on storage needs before the layout is finalised, not after tiling is complete.
Noisy pipes and water hammer
A banging sound when a tap or toilet valve shuts off (water hammer) is usually caused by a pressure surge in the pipework, sometimes fixed by fitting a water hammer arrestor near the affected fixture rather than needing to replace pipework throughout.