Plumbing regulations, FAQ
Do I need a certificate for a new bathroom? There's no single certificate like Part P for electrics, but any work must comply with Water Fittings Regulations, and gas-connected work needs a Gas Safe engineer. Can I do my own plumbing? Straightforward repairs, yes; anything affecting the public water supply (like a new connection) should go through a WaterSafe-approved plumber.
Immersion heaters and hot water cylinders
An immersion heater is an electric backup for heating water in a cylinder, useful if the boiler fails or as the main hot water source in an all-electric property. If yours is tripping the electrics or not heating water, it's sometimes the heating element itself rather than the boiler or cylinder at fault.
What a good plumbing quote should include
A proper quote should state the scope of work, whether parts are included in the price or charged separately, an estimate of how long the job will take, and what happens if the job turns out to be bigger than expected once work starts (a common scenario with older pipework).
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.
Aftercare after plumbing work
After a boiler installation or bathroom refit, you should receive a benchmark/commissioning checklist (for a boiler) or a written summary of the work done, which you'll want if you make an insurance claim or sell the property later. Keep it with your household paperwork alongside any appliance warranties.
What's involved in a bathroom refit
A full bathroom refit usually means removing the old suite, checking and often replacing the pipework behind it (since it's rarely accessible again once tiled over), first-fix plumbing before tiling, then second-fix (taps, shower, toilet cistern) once the room is finished. Waterproofing (tanking) around a shower area is a step worth confirming is included, not assumed.
Copper vs plastic pipework
Copper pipework is the traditional standard and suits exposed runs; plastic (PEX/push-fit) pipework is faster to install and commonly used for pipework buried in walls or floors where copper joints would be harder to check later. Most plumbers use a mix depending on the specific run, not one material throughout.
When plumbing work needs a Gas Safe engineer instead
Plumbers can install and repair most water systems, but any work on a gas appliance or gas pipework — a boiler, a gas fire, a gas hob — is illegal for anyone who isn't on the Gas Safe Register, by law. If a job involves both plumbing and a gas connection (moving a boiler, for example), check whether your plumber is also Gas Safe registered before booking.