Hard water and your plumbing
In hard water areas, limescale builds up inside pipes, taps, showerheads and boiler heat exchangers over time, gradually reducing efficiency and flow. A plumber working in a hard water area may recommend a water softener or scale inhibitor as part of a boiler installation, particularly for a system that's expected to last 10+ years.
Plumbing in a washing machine or dishwasher
Both need a cold water supply, a drain connection, and in most cases their own isolation valves so they can be disconnected without turning off water to the whole property. Using a shared valve with another appliance is a common shortcut that makes future repairs more disruptive than it needs to be.
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.
Blocked drains — causes and what a plumber checks
Slow-draining sinks are usually a local blockage (grease, hair, food waste) that a plumber can often clear with rodding or a drain snake. A blockage affecting multiple fixtures at once, or gurgling sounds from other drains, points to something further down the system — sometimes needing a drain camera survey rather than guesswork.
Combi vs system vs conventional boilers
A combi boiler heats water on demand with no separate tank, suits smaller properties with one bathroom. A system boiler uses a hot water cylinder but no cold water tank, better for higher demand. A conventional (regular) boiler uses both a cylinder and a tank, common in older properties and useful where mains pressure is poor.
Water meters and leak awareness
An unexplained rise in your water bill, or a water meter that keeps ticking over when nothing's running in the property, is one of the clearest early signs of a hidden leak. Most water companies can help identify whether the leak is on your side of the meter (your responsibility) or theirs.
What affects the cost
Cost depends on the scope of the job, how accessible the pipework is (under a floor vs behind a wall), whether parts need to be sourced specially, and whether the job is planned or an emergency call-out. A simple tap or valve replacement is usually quick and low-cost; anything requiring pipework to be rerouted, or walls/floors to be opened up, costs more partly because of the making-good work afterwards.
Boiler pressure and heating faults
Most combi boilers run best between 1 and 1.5 bar of pressure — too low and the heating cuts out, too high and the pressure relief valve can discharge. A plumber checking a heating fault will usually look at pressure, check for trapped air in radiators (bleeding), and check the pump and diverter valve before assuming a full boiler fault.