Combi vs system vs conventional boilers
A combi boiler heats water on demand with no separate tank, suits smaller properties with one bathroom. A system boiler uses a hot water cylinder but no cold water tank, better for higher demand. A conventional (regular) boiler uses both a cylinder and a tank, common in older properties and useful where mains pressure is poor.
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.
Plumbing emergencies — what to do first
For a burst pipe or major leak, turn off the water at the stopcock (usually under the kitchen sink or where the supply enters the property) before calling anyone — this limits water damage while you wait. For no hot water or heating, check the boiler pressure gauge first; a common cause is low pressure, which some homeowners can safely top up themselves via the filling loop.
Plumbing regulations, FAQ
Do I need a certificate for a new bathroom? There's no single certificate like Part P for electrics, but any work must comply with Water Fittings Regulations, and gas-connected work needs a Gas Safe engineer. Can I do my own plumbing? Straightforward repairs, yes; anything affecting the public water supply (like a new connection) should go through a WaterSafe-approved plumber.
How many quotes should you get?
Three is a reasonable number for most plumbing jobs — enough to spot an outlier without asking too many people to visit for a straightforward repair. For a planned job like a bathroom refit, make sure each quote covers the same scope, since a lower price sometimes means less is included, not better value.
How plumbing quotes work
Describe the job, including whether it's an emergency, a planned repair, or a full installation, and mention access — under a suspended floor is very different from behind fitted units. Plumbers use this for an initial estimate; the final price is usually confirmed once they've seen the fault or the space in person.
What WaterSafe registration means
WaterSafe is the umbrella body for the UK's Approved Contractor Person schemes (including APHC, CIPHE, WIAPS and SNIPEF). A WaterSafe-approved plumber has been assessed on their knowledge of the Water Fittings Regulations, which exist to stop poor installation work or substandard products contaminating the drinking water supply — not just general plumbing competence.
What a boiler fault code usually means
Modern combi boilers display a fault code when something's wrong rather than just stopping — the exact meaning varies by manufacturer, but common causes behind a "no heat" code include low pressure, a faulty sensor, or an ignition fault. Note the code before calling a plumber; it speeds up diagnosis considerably.