Red flags in a cheap plumbing quote
A quote significantly below the others is worth questioning before accepting — check it specifies the same quality of parts (a boiler make/model, not just "a boiler"), includes making good after any pipework is exposed, and covers testing before the job is signed off as complete.
How long does plumbing work take?
A tap or valve replacement is usually under an hour. A full bathroom refit commonly takes 5 to 10 working days depending on scope, plus time for tiling and decorating that isn't part of the plumbing work itself. A boiler swap is typically a one-day job if it's a straightforward like-for-like replacement.
When plumbing work needs a Gas Safe engineer instead
Plumbers can install and repair most water systems, but any work on a gas appliance or gas pipework — a boiler, a gas fire, a gas hob — is illegal for anyone who isn't on the Gas Safe Register, by law. If a job involves both plumbing and a gas connection (moving a boiler, for example), check whether your plumber is also Gas Safe registered before booking.
Boiler pressure and heating faults
Most combi boilers run best between 1 and 1.5 bar of pressure — too low and the heating cuts out, too high and the pressure relief valve can discharge. A plumber checking a heating fault will usually look at pressure, check for trapped air in radiators (bleeding), and check the pump and diverter valve before assuming a full boiler fault.
Blocked drains — causes and what a plumber checks
Slow-draining sinks are usually a local blockage (grease, hair, food waste) that a plumber can often clear with rodding or a drain snake. A blockage affecting multiple fixtures at once, or gurgling sounds from other drains, points to something further down the system — sometimes needing a drain camera survey rather than guesswork.
Three steps to hiring the right plumber
First, check they're registered with a WaterSafe scheme (or Gas Safe too, if the job needs it) and ask for the registration number. Second, get a written quote that separates labour from parts. Third, ask what happens if the job uncovers a bigger problem — a good plumber will tell you before continuing, not after.
What WaterSafe registration means
WaterSafe is the umbrella body for the UK's Approved Contractor Person schemes (including APHC, CIPHE, WIAPS and SNIPEF). A WaterSafe-approved plumber has been assessed on their knowledge of the Water Fittings Regulations, which exist to stop poor installation work or substandard products contaminating the drinking water supply — not just general plumbing competence.
What is a power flush and do you need one?
A power flush clears sludge and debris from a central heating system's radiators and pipework using a pumped chemical flush — usually recommended if radiators are cold at the bottom, or before installing a new boiler onto an older system, so the new boiler isn't immediately clogged by old sludge.