What is a power flush and do you need one?
A power flush clears sludge and debris from a central heating system's radiators and pipework using a pumped chemical flush — usually recommended if radiators are cold at the bottom, or before installing a new boiler onto an older system, so the new boiler isn't immediately clogged by old sludge.
Plumbing responsibilities for landlords
Landlords are responsible for keeping water and heating systems in safe working order, and if there's a gas boiler, a valid annual Gas Safety Certificate is a legal requirement, not optional. A burst pipe or heating failure in a rented property is generally treated as an emergency repair the landlord must address promptly.
Heat pumps and eco-friendly heating options
Some plumbers also work on or alongside heat pump installations, though this is often a joint job with a heating engineer for the heat pump unit itself. If you're considering moving away from a gas boiler, it's worth asking whether your plumber does this work directly or partners with someone who does.
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.
When plumbing work needs a Gas Safe engineer instead
Plumbers can install and repair most water systems, but any work on a gas appliance or gas pipework — a boiler, a gas fire, a gas hob — is illegal for anyone who isn't on the Gas Safe Register, by law. If a job involves both plumbing and a gas connection (moving a boiler, for example), check whether your plumber is also Gas Safe registered before booking.
Plumbing emergencies — what to do first
For a burst pipe or major leak, turn off the water at the stopcock (usually under the kitchen sink or where the supply enters the property) before calling anyone — this limits water damage while you wait. For no hot water or heating, check the boiler pressure gauge first; a common cause is low pressure, which some homeowners can safely top up themselves via the filling loop.
Blocked drains — causes and what a plumber checks
Slow-draining sinks are usually a local blockage (grease, hair, food waste) that a plumber can often clear with rodding or a drain snake. A blockage affecting multiple fixtures at once, or gurgling sounds from other drains, points to something further down the system — sometimes needing a drain camera survey rather than guesswork.
Low water pressure — common causes
Low pressure can come from a partially closed stopcock, a fault with the water company's supply, scale build-up in old pipework, or (for a shower specifically) the type of shower valve fitted. A plumber can usually diagnose which of these it is by checking pressure at more than one fixture, rather than assuming it's the mains supply.