Low water pressure — common causes
Low pressure can come from a partially closed stopcock, a fault with the water company's supply, scale build-up in old pipework, or (for a shower specifically) the type of shower valve fitted. A plumber can usually diagnose which of these it is by checking pressure at more than one fixture, rather than assuming it's the mains supply.
Blocked drains — causes and what a plumber checks
Slow-draining sinks are usually a local blockage (grease, hair, food waste) that a plumber can often clear with rodding or a drain snake. A blockage affecting multiple fixtures at once, or gurgling sounds from other drains, points to something further down the system — sometimes needing a drain camera survey rather than guesswork.
Three steps to hiring the right plumber
First, check they're registered with a WaterSafe scheme (or Gas Safe too, if the job needs it) and ask for the registration number. Second, get a written quote that separates labour from parts. Third, ask what happens if the job uncovers a bigger problem — a good plumber will tell you before continuing, not after.
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.
Protecting pipes in cold weather
Pipes in unheated spaces — lofts, garages, outbuildings — are the most common source of a winter burst pipe once temperatures drop below freezing for a sustained period. Lagging exposed pipework and keeping heating on a low constant setting during a cold snap, rather than off, are the two most effective preventive steps.
Plumbing regulations, FAQ
Do I need a certificate for a new bathroom? There's no single certificate like Part P for electrics, but any work must comply with Water Fittings Regulations, and gas-connected work needs a Gas Safe engineer. Can I do my own plumbing? Straightforward repairs, yes; anything affecting the public water supply (like a new connection) should go through a WaterSafe-approved plumber.
Do you know where your stopcock is?
Every property has a main stopcock (usually under the kitchen sink, though sometimes in a different location in older or converted properties) that shuts off the water supply. Knowing where it is and checking it turns freely, before you need it in an emergency, is one of the simplest things a homeowner can do.
Workmanship guarantees on plumbing work
Most registered plumbers offer a workmanship guarantee separate from any manufacturer's warranty on parts like a boiler or a shower unit — commonly 12 months upwards. Ask what's specifically covered: a guarantee on a bathroom refit should cover the plumbing work itself, not just the visible fittings.