Plumbing emergencies — what to do first
For a burst pipe or major leak, turn off the water at the stopcock (usually under the kitchen sink or where the supply enters the property) before calling anyone — this limits water damage while you wait. For no hot water or heating, check the boiler pressure gauge first; a common cause is low pressure, which some homeowners can safely top up themselves via the filling loop.
What's involved in a bathroom refit
A full bathroom refit usually means removing the old suite, checking and often replacing the pipework behind it (since it's rarely accessible again once tiled over), first-fix plumbing before tiling, then second-fix (taps, shower, toilet cistern) once the room is finished. Waterproofing (tanking) around a shower area is a step worth confirming is included, not assumed.
Shared water supplies in flats and conversions
In a converted property, check whether your flat has its own independent stopcock and supply, or shares one with other flats via a communal system. A shared supply can mean a repair affects your neighbours too, and sometimes needs freeholder involvement before work starts.
Immersion heaters and hot water cylinders
An immersion heater is an electric backup for heating water in a cylinder, useful if the boiler fails or as the main hot water source in an all-electric property. If yours is tripping the electrics or not heating water, it's sometimes the heating element itself rather than the boiler or cylinder at fault.
Combi vs system vs conventional boilers
A combi boiler heats water on demand with no separate tank, suits smaller properties with one bathroom. A system boiler uses a hot water cylinder but no cold water tank, better for higher demand. A conventional (regular) boiler uses both a cylinder and a tank, common in older properties and useful where mains pressure is poor.
What is a power flush and do you need one?
A power flush clears sludge and debris from a central heating system's radiators and pipework using a pumped chemical flush — usually recommended if radiators are cold at the bottom, or before installing a new boiler onto an older system, so the new boiler isn't immediately clogged by old sludge.
Common plumbing jobs
Plumbers handle everything from a dripping tap to a full bathroom re-pipe: fixing leaks, clearing blocked drains, replacing taps and valves, fitting new bathroom suites, repairing or replacing radiators, and connecting appliances like washing machines and dishwashers. Emergency work (burst pipes, no hot water) is usually handled separately from planned jobs like a bathroom refit.
First fix and second fix plumbing
On a new build or extension, "first fix" is running pipework through walls and floors before they're closed up; "second fix" is fitting the visible taps, radiators and appliances once decorating is done. Timing this with other trades on site matters — pipework needs to be pressure-tested before it's covered over, not after.