Common plumbing myths, busted
"A dripping tap is just cosmetic" — left long enough it wastes real water and can damage the fitting further. "Any handyman can fit a boiler" — boiler work involving gas connections legally needs a Gas Safe engineer, not just a plumber. "Bleeding a radiator fixes all heating faults" — it only helps with trapped air, not pressure or pump issues.
How plumbing quotes work
Describe the job, including whether it's an emergency, a planned repair, or a full installation, and mention access — under a suspended floor is very different from behind fitted units. Plumbers use this for an initial estimate; the final price is usually confirmed once they've seen the fault or the space in person.
Seasonal plumbing checks worth doing
Before winter: check outside tap isolation valves, and consider draining down any external pipework not in regular use. Before summer: check garden irrigation and outside tap connections for wear, since these see much more use once the weather turns. A five-minute check avoids most seasonal callouts.
When plumbing work needs a Gas Safe engineer instead
Plumbers can install and repair most water systems, but any work on a gas appliance or gas pipework — a boiler, a gas fire, a gas hob — is illegal for anyone who isn't on the Gas Safe Register, by law. If a job involves both plumbing and a gas connection (moving a boiler, for example), check whether your plumber is also Gas Safe registered before booking.
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.
Understanding the labour vs materials split
Materials — pipework, fittings, a new boiler or bathroom suite — are often a smaller share of a plumbing quote than labour, particularly for jobs involving lifting floors or chasing walls. If a quote looks unusually cheap, check whether it specifies the same brand/quality of fittings as a competing quote, not just a lower labour rate.
Finding a hidden leak
A leak inside a wall or under a floor isn't always obvious until it shows as a damp patch or a high water bill. Plumbers use damp meters, thermal imaging or (for harder cases) tracer gas to locate a hidden leak without having to open up an entire wall speculatively — worth asking about before agreeing to exploratory work.
Blocked drains — causes and what a plumber checks
Slow-draining sinks are usually a local blockage (grease, hair, food waste) that a plumber can often clear with rodding or a drain snake. A blockage affecting multiple fixtures at once, or gurgling sounds from other drains, points to something further down the system — sometimes needing a drain camera survey rather than guesswork.