When plumbing work needs a Gas Safe engineer instead
Plumbers can install and repair most water systems, but any work on a gas appliance or gas pipework — a boiler, a gas fire, a gas hob — is illegal for anyone who isn't on the Gas Safe Register, by law. If a job involves both plumbing and a gas connection (moving a boiler, for example), check whether your plumber is also Gas Safe registered before booking.
Low water pressure — common causes
Low pressure can come from a partially closed stopcock, a fault with the water company's supply, scale build-up in old pipework, or (for a shower specifically) the type of shower valve fitted. A plumber can usually diagnose which of these it is by checking pressure at more than one fixture, rather than assuming it's the mains supply.
Plumbing responsibilities for landlords
Landlords are responsible for keeping water and heating systems in safe working order, and if there's a gas boiler, a valid annual Gas Safety Certificate is a legal requirement, not optional. A burst pipe or heating failure in a rented property is generally treated as an emergency repair the landlord must address promptly.
What is a power flush and do you need one?
A power flush clears sludge and debris from a central heating system's radiators and pipework using a pumped chemical flush — usually recommended if radiators are cold at the bottom, or before installing a new boiler onto an older system, so the new boiler isn't immediately clogged by old sludge.
Immersion heaters and hot water cylinders
An immersion heater is an electric backup for heating water in a cylinder, useful if the boiler fails or as the main hot water source in an all-electric property. If yours is tripping the electrics or not heating water, it's sometimes the heating element itself rather than the boiler or cylinder at fault.
Finding a hidden leak
A leak inside a wall or under a floor isn't always obvious until it shows as a damp patch or a high water bill. Plumbers use damp meters, thermal imaging or (for harder cases) tracer gas to locate a hidden leak without having to open up an entire wall speculatively — worth asking about before agreeing to exploratory work.
Hard water and your plumbing
In hard water areas, limescale builds up inside pipes, taps, showerheads and boiler heat exchangers over time, gradually reducing efficiency and flow. A plumber working in a hard water area may recommend a water softener or scale inhibitor as part of a boiler installation, particularly for a system that's expected to last 10+ years.
Do you know where your stopcock is?
Every property has a main stopcock (usually under the kitchen sink, though sometimes in a different location in older or converted properties) that shuts off the water supply. Knowing where it is and checking it turns freely, before you need it in an emergency, is one of the simplest things a homeowner can do.