Three steps to hiring the right plumber
First, check they're registered with a WaterSafe scheme (or Gas Safe too, if the job needs it) and ask for the registration number. Second, get a written quote that separates labour from parts. Third, ask what happens if the job uncovers a bigger problem — a good plumber will tell you before continuing, not after.
Seasonal plumbing checks worth doing
Before winter: check outside tap isolation valves, and consider draining down any external pipework not in regular use. Before summer: check garden irrigation and outside tap connections for wear, since these see much more use once the weather turns. A five-minute check avoids most seasonal callouts.
What WaterSafe registration means
WaterSafe is the umbrella body for the UK's Approved Contractor Person schemes (including APHC, CIPHE, WIAPS and SNIPEF). A WaterSafe-approved plumber has been assessed on their knowledge of the Water Fittings Regulations, which exist to stop poor installation work or substandard products contaminating the drinking water supply — not just general plumbing competence.
Plumbing responsibilities for landlords
Landlords are responsible for keeping water and heating systems in safe working order, and if there's a gas boiler, a valid annual Gas Safety Certificate is a legal requirement, not optional. A burst pipe or heating failure in a rented property is generally treated as an emergency repair the landlord must address promptly.
How plumbing quotes work
Describe the job, including whether it's an emergency, a planned repair, or a full installation, and mention access — under a suspended floor is very different from behind fitted units. Plumbers use this for an initial estimate; the final price is usually confirmed once they've seen the fault or the space in person.
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.
Copper vs plastic pipework
Copper pipework is the traditional standard and suits exposed runs; plastic (PEX/push-fit) pipework is faster to install and commonly used for pipework buried in walls or floors where copper joints would be harder to check later. Most plumbers use a mix depending on the specific run, not one material throughout.
Blocked drains — causes and what a plumber checks
Slow-draining sinks are usually a local blockage (grease, hair, food waste) that a plumber can often clear with rodding or a drain snake. A blockage affecting multiple fixtures at once, or gurgling sounds from other drains, points to something further down the system — sometimes needing a drain camera survey rather than guesswork.