Combi vs system vs conventional boilers
A combi boiler heats water on demand with no separate tank, suits smaller properties with one bathroom. A system boiler uses a hot water cylinder but no cold water tank, better for higher demand. A conventional (regular) boiler uses both a cylinder and a tank, common in older properties and useful where mains pressure is poor.
What affects the cost
Cost depends on the scope of the job, how accessible the pipework is (under a floor vs behind a wall), whether parts need to be sourced specially, and whether the job is planned or an emergency call-out. A simple tap or valve replacement is usually quick and low-cost; anything requiring pipework to be rerouted, or walls/floors to be opened up, costs more partly because of the making-good work afterwards.
Three steps to hiring the right plumber
First, check they're registered with a WaterSafe scheme (or Gas Safe too, if the job needs it) and ask for the registration number. Second, get a written quote that separates labour from parts. Third, ask what happens if the job uncovers a bigger problem — a good plumber will tell you before continuing, not after.
Hard water and your plumbing
In hard water areas, limescale builds up inside pipes, taps, showerheads and boiler heat exchangers over time, gradually reducing efficiency and flow. A plumber working in a hard water area may recommend a water softener or scale inhibitor as part of a boiler installation, particularly for a system that's expected to last 10+ years.
Understanding the labour vs materials split
Materials — pipework, fittings, a new boiler or bathroom suite — are often a smaller share of a plumbing quote than labour, particularly for jobs involving lifting floors or chasing walls. If a quote looks unusually cheap, check whether it specifies the same brand/quality of fittings as a competing quote, not just a lower labour rate.
Water-based underfloor heating, what's involved
Unlike electric underfloor heating, a water-based system runs off your boiler via a manifold and needs the floor buildup to accommodate the pipework — usually easier to fit during a renovation than retrofit into a finished floor. It's often paired with a lower-temperature heating setup than radiators use.
Red flags in a cheap plumbing quote
A quote significantly below the others is worth questioning before accepting — check it specifies the same quality of parts (a boiler make/model, not just "a boiler"), includes making good after any pipework is exposed, and covers testing before the job is signed off as complete.
Outside taps and garden plumbing
An outside tap needs its own isolation valve and, in colder areas, either an internal shut-off you can drain down for winter or a proper anti-frost design — a poorly installed one is a common cause of a burst pipe in cold weather. This is separate from the electrical requirements for any pond or irrigation pump also being installed.