Copper vs plastic pipework
Copper pipework is the traditional standard and suits exposed runs; plastic (PEX/push-fit) pipework is faster to install and commonly used for pipework buried in walls or floors where copper joints would be harder to check later. Most plumbers use a mix depending on the specific run, not one material throughout.
How many quotes should you get?
Three is a reasonable number for most plumbing jobs — enough to spot an outlier without asking too many people to visit for a straightforward repair. For a planned job like a bathroom refit, make sure each quote covers the same scope, since a lower price sometimes means less is included, not better value.
What a boiler fault code usually means
Modern combi boilers display a fault code when something's wrong rather than just stopping — the exact meaning varies by manufacturer, but common causes behind a "no heat" code include low pressure, a faulty sensor, or an ignition fault. Note the code before calling a plumber; it speeds up diagnosis considerably.
Do you know where your stopcock is?
Every property has a main stopcock (usually under the kitchen sink, though sometimes in a different location in older or converted properties) that shuts off the water supply. Knowing where it is and checking it turns freely, before you need it in an emergency, is one of the simplest things a homeowner can do.
Immersion heaters and hot water cylinders
An immersion heater is an electric backup for heating water in a cylinder, useful if the boiler fails or as the main hot water source in an all-electric property. If yours is tripping the electrics or not heating water, it's sometimes the heating element itself rather than the boiler or cylinder at fault.
Understanding the labour vs materials split
Materials — pipework, fittings, a new boiler or bathroom suite — are often a smaller share of a plumbing quote than labour, particularly for jobs involving lifting floors or chasing walls. If a quote looks unusually cheap, check whether it specifies the same brand/quality of fittings as a competing quote, not just a lower labour rate.
What affects the cost
Cost depends on the scope of the job, how accessible the pipework is (under a floor vs behind a wall), whether parts need to be sourced specially, and whether the job is planned or an emergency call-out. A simple tap or valve replacement is usually quick and low-cost; anything requiring pipework to be rerouted, or walls/floors to be opened up, costs more partly because of the making-good work afterwards.
Seasonal plumbing checks worth doing
Before winter: check outside tap isolation valves, and consider draining down any external pipework not in regular use. Before summer: check garden irrigation and outside tap connections for wear, since these see much more use once the weather turns. A five-minute check avoids most seasonal callouts.