What is a power flush and do you need one?
A power flush clears sludge and debris from a central heating system's radiators and pipework using a pumped chemical flush — usually recommended if radiators are cold at the bottom, or before installing a new boiler onto an older system, so the new boiler isn't immediately clogged by old sludge.
Immersion heaters and hot water cylinders
An immersion heater is an electric backup for heating water in a cylinder, useful if the boiler fails or as the main hot water source in an all-electric property. If yours is tripping the electrics or not heating water, it's sometimes the heating element itself rather than the boiler or cylinder at fault.
Plumbing regulations, FAQ
Do I need a certificate for a new bathroom? There's no single certificate like Part P for electrics, but any work must comply with Water Fittings Regulations, and gas-connected work needs a Gas Safe engineer. Can I do my own plumbing? Straightforward repairs, yes; anything affecting the public water supply (like a new connection) should go through a WaterSafe-approved plumber.
Do you know where your stopcock is?
Every property has a main stopcock (usually under the kitchen sink, though sometimes in a different location in older or converted properties) that shuts off the water supply. Knowing where it is and checking it turns freely, before you need it in an emergency, is one of the simplest things a homeowner can do.
What's involved in a bathroom refit
A full bathroom refit usually means removing the old suite, checking and often replacing the pipework behind it (since it's rarely accessible again once tiled over), first-fix plumbing before tiling, then second-fix (taps, shower, toilet cistern) once the room is finished. Waterproofing (tanking) around a shower area is a step worth confirming is included, not assumed.
Three steps to hiring the right plumber
First, check they're registered with a WaterSafe scheme (or Gas Safe too, if the job needs it) and ask for the registration number. Second, get a written quote that separates labour from parts. Third, ask what happens if the job uncovers a bigger problem — a good plumber will tell you before continuing, not after.
Plumbing emergencies — what to do first
For a burst pipe or major leak, turn off the water at the stopcock (usually under the kitchen sink or where the supply enters the property) before calling anyone — this limits water damage while you wait. For no hot water or heating, check the boiler pressure gauge first; a common cause is low pressure, which some homeowners can safely top up themselves via the filling loop.
Combi vs system vs conventional boilers
A combi boiler heats water on demand with no separate tank, suits smaller properties with one bathroom. A system boiler uses a hot water cylinder but no cold water tank, better for higher demand. A conventional (regular) boiler uses both a cylinder and a tank, common in older properties and useful where mains pressure is poor.